I have an Asus Sabertooth X99 with G.SKILL Ripjaws 4 Series 32GB (4 x 8GB) DDR4 2666 F4-2666C15Q-32GRR.
I have been using it for a week at the stock setup because I've been testing the processor. However, today I set XMP and adjusted the CPU speeds back to their proper setting and it would not boot. I then tried resetting the motherboard to factory defaults, reboot, chose XMP again, and when it reboot I got a single long beep and 2 short beeps.
As it stands I am not able to boot if XMP is selected.
I have been able to set it manually, but I'm worried the timings are going to be all screwed up. If I reset the motherboard to default, would the primary, secondary, and tertiary settings be the same? If so, I suppose I could just write them all down and set it manually.
I have been using it for a week at the stock setup because I've been testing the processor. However, today I set XMP and adjusted the CPU speeds back to their proper setting and it would not boot. I then tried resetting the motherboard to factory defaults, reboot, chose XMP again, and when it reboot I got a single long beep and 2 short beeps.
As it stands I am not able to boot if XMP is selected.
I have been able to set it manually, but I'm worried the timings are going to be all screwed up. If I reset the motherboard to default, would the primary, secondary, and tertiary settings be the same? If so, I suppose I could just write them all down and set it manually.
Comment