Announcement

Collapse
No announcement yet.

Gigabyte RP43T-UD3L-Ripjaws-F3-10666CL9D-4GBRL

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Gigabyte RP43T-UD3L-Ripjaws-F3-10666CL9D-4GBRL

    Hello all,

    Could any kind soul give some advice?

    I have a gigabyte EP43T-UD3L with Ripjaws F3-10666CL9D-4GBRL (2GBx2)

    Ok everything setup in the bios manually with recommended settings on memory box.
    I'm experiencing instability: BSOD, apps hanging, apps crashing.
    Tried running win xp and win 7 to see if any difference. None seen.

    Thought it was the memory be running them through Memtest86.
    Instant crash when running both sticks.
    Ran single all results ok.

    Led me to beleive error on the mainboard.
    So ran memtest86 again signle slots each time all ok, but noticed that Memtest86 reports on my DDR slot 3 and 4 as DDR2.

    Has anybody using one of these mainboards got this type of problem?

    Got an RMA for the ripjaws, but I don't think it is them.

    Any ideas?

    Thanks in advance

    John (UK)
    Tags: None
  • #2
    Hello again all,

    Just been out and bought exactly the same board from a different suppier and same results.

    Is this definatley the memory then?

    If so how much does it cost me to RMA it from the UK?
    Best courier for the job?

    Thanks again

    John

    Comment

    • #3
      Make sure all memory settings are properly configured in BIOS. Do you have the latest BIOS for the motherboard? Very odd that they work fine individually but not together.

      Thank you
      GSKILL TECH

      Comment

      • #4
        Hello G-Skill,

        Thanks for the response, sorry not replied been on holiday..

        Ok, here is my bios settings if that helps?
        Sorry I'm not an overclocker, so don't know what a lot of you guys are on about..

        Clock Chip Control
        CPU Host Clock Control: Enabled
        CPU Host Clock Freq: 333
        PCI Express Freq: AUTO
        C.I.A.2: Disabled

        Dram Performance Control
        Performance Enhance: Standard
        (G)MCH Frequency Latch: AUTO
        System Memory Multiplier (SPD): 4.00D
        Memory Freq: 1333
        Dram Timing Selectable (SPD): MANUAL

        Standard Timing Control
        CAS Latency Time: 9
        tRCD: 9
        tRP: 9
        tRAS: 24

        Dram Voltage: 1.500v
        Dram Termination: 0.750v

        Latest Bios running F6

        Thanks again
        John

        Comment

        • #5
          You will want to set System Memory Multiplier to AUTO or 4.00B. I don't think "D" is correct for CPU Host Clock Freq: 333

          Thank you
          GSKILL TECH

          Comment

          Previous template Next
          Working...
          X