OC'ing 8GB of F2-8500CL5D-4GBPK w/ Abit IP-35Pro and E6850

[philly]

still not showing.. dump to tinypic.com and copy link would probably do better.

Please see attached. Thank you much! Hope this and new settings will resolve the issue

http://i44.tinypic.com/qxmk2w.jpg

http://i40.tinypic.com/2mcbm86.jpg

http://i44.tinypic.com/v2qkk5.jpg

http://i43.tinypic.com/vf9ftz.jpg

Thank you!

[GSKILL TECH]

Very odd I'd have to say...

What is your bus clock in CPU-z? The memory divider is correct...

Thank you
GSKILL TECH

[philly]

In CPU-z it shows 2048Mhz instead of 3.7Mhz which is in Bios.

In Control Panel it shows right as in Bios. I believe CPU-Z doesn't show correct numbers maybe

Is my Bios memory settings correct? What might be went wrong? Please advise.

Thank you!

[philly]

Bus Speed: 333Mhz

[GSKILL TECH]

CPU-z may show 2048 because you have stepping on. If you open a program, it should jump back up.

The problem is bus speed at 333, your system is not taking the 418 overclock... which is odd.

Thank you
GSKILL TECH

[philly]

It shows 340 Mhz? is it still odd? What shall I change in settings please. Any advise?

[philly]

Are my memory settings right? Why is the 408 Mhz for RAM which supposed to be 800Mhz?

[GSKILL TECH]

No, DDR is double data rate. So 408MHz x 2 = DDR2-816

DDR2-1000 should show ~500MHz

Thank you
GSKILL TECH

[philly]

Let me Redo all settings in Bios again and I'll post new settings with Cpu as well. Thanks!

[philly]

Please take a look. Any suggestions? Multiplier in Bios is 9 but in CPU-z is x6

http://i39.tinypic.com/293edj4.jpg

http://i44.tinypic.com/10gjy82.jpg

http://i39.tinypic.com/j6jyuh.jpg

http://i39.tinypic.com/25apwrp.jpg

http://i43.tinypic.com/286vfgm.jpg

[philly]

Also, could you please suggest if the tCFR 63 is correct? This is the maximum in my BIOS but you've suggested 80 for the 4 sticks. Thank you!

[GSKILL TECH]

tRFC can only be 63 because your motherboard was originally made for DDR2-800 max. Also, the reason why CPU Ratio is lower is because the system is not active, once you run a program it should jump back to x9.

Thank you
GSKILL TECH

[philly]

Got it! Thank you