Running F3-12800CL9T-6GBNQ modules at 1333 or 1600 possible on X58A-UD3R mobo?

[Ouro]

Installed the G.Skill modules and manually set the timing to 9,9,9,24 (default was 7,7,7,20 and the system was unstable). The RAM is still running at 1066. I am wondering what BIOS settings I can change to get this to 1600 or at least 1333. OC'ing is an option. Thanks in advance!

Specs
CPU: Intel Core i7-930 2.8GHz LGA 1366
MOBO: GIGABYTE X58A-UD3R
RAM: G.SKILL 12800CL9T-6GBNQ DDR3-1600
Hyper 212 Plus Cooler Master
OCZ GameXStream 850 PSU

[GSKILL TECH]

Should look something like this:

In MIT (MB Intelligent Tweaker):

CPU Clock Ratio - 21x
QPI Link Speed - AUTO
Base Clock Control - Enabled
BCLK Frequency - 133
Performance Enhance - Standard
Extreme Memory Profile - Disabled
System Memory Multiplier - 12

DRAM Timing Selectable - Manual

CAS Latency Time - 9
tRCD - 9
tRP - 9
tRAS - 24

Enter these for the other three as well.

Channel A Timing Settings

Advanced Timings
Command Rate - 2

DRAM Voltage - 1.500V
Rest to AUTO

Thank you
GSKILL TECH

[Ouro]

Thanks for your help!

I believe my problems were actually caused by the heat sink being secured too tightly. After loosening the heat sink, the RAM and core issues I was having have gone away. My system is up and running, and actually OC'd to 3.6Ghz and stable.

[GSKILL TECH]

Sounds good! Happens all the time. Enjoy! =)

Thank you
GSKILL TECH