unstable pc

[mdole]

GIGABYTE X58A-UD3R with f3-15000cl9t-6gbtd problem.
They run at a speed of 1066Mhz instead of 1866Mhz.

What shold i change in MIT ?

[GSKILL TECH]

In MIT (MB Intelligent Tweaker):

CPU Clock Ratio - 21x
QPI Link Speed - AUTO
Base Clock Control - Enabled
BCLK Frequency - 133
Performance Enhance - Standard
Extreme Memory Profile - Disabled
System Memory Multiplier - 14

DRAM Timing Selectable - Manual

CAS Latency Time - 9
tRCD - 9
tRP - 9
tRAS - 24

Enter these for the other three as well.

Channel A Timing Settings

Advanced Timings
Command Rate - 2

Advanced Voltage Control
Load-Line Calibration - Disabled
QPI/VTT Voltage - 1.50V

DRAM Voltage - 1.640V
Rest to AUTO

Thank you
GSKILL SUPPORT

[mdole]

doesnt work

hi,

the comp is still unstable (blue screens aftr 5 minutes)
even when i change it back to 1066MHZ (default)

can you check it again please ?

[Tradesman]

What CPU do you have and could you post your BIOS settings

[GSKILL TECH]

Test one stick at a time with AUTO settings to see if all modules are OK.

Thank you
GSKILL TECH