If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the
register
link to proceed. To start viewing messages,
select the forum you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Ideal BIOS settings for F3-12800CL7D-4GBRH with GA-P55-UD3R?
It surely is compatible. Here are the BIOS settings should you need them:
Advanced CPU Features:
CPU Clock Ratio ................................ [18x] or increase for slight OC
Intel(R) Turbo Boost Tech .................. [Disabled]
CPU Cores Enabled ............................ [All]
CPU Multi Threading .......................... [Enabled]
C3/C6/C7 State Support ................... [Auto]
CPU Enhanced Halt (C1E) ................... [Auto]
C3/C6/C7 State Support .................... [Auto]
CPU Thermal Monitor ......................... [Auto]
CPU EIST Function ............................ [Disabled]
Virtualization Technology ................... [Disabled]
Bi-Directional PROCHOT ..................... [Auto]
Uncore & QPI Features:
QPI Clock Ratio ...........................................AUTO
QPI Link Speed .............................. AUTO
Uncore Clock Ratio...........................AUTO
Uncore Frequency .......................... AUTO
Isonchronous Frequency ..................[Enabled]
Standard Clock Control:
Base Clock (BCLK) Control ................ [Enabled]
BCLK Frequency (MHz) ..................... 160
PCI Express Frequency (MHz) ........... [100]
C.I.A.2 [Disabled]
Advanced Clock Control:
CPU Clock Drive ..............................[800mV]
PCI Express Clock Drive ................... [900mV]
CPU Clock Skew ............................. [0ps]
Advanced DRAM Features:
Extreme Memory Profile (X.M.P) ......... [Disabled]
System Memory Multiplier (SPD) ........ [10.0]
Performance Enhance ...................... [Standard]
DRAM Timing Selectable (SPD) .......... [Expert]
Channel A + B + C
Channel A Timing Settings:
##Channel A Standard Timing Control##
CAS Latency Time ...................... 7
tRCD ....................................... 7
tRP ......................................... 7
tRAS ....................................... 24
##Channel A Advanced Timing Control##
Command Rate (CMD) ................ 2
Advanced Voltage Control:
CPU
Load Line Calibration ................. [Disabled]
CPU Vcore ............................... 1.275 [1.2750V]
QPI/VTT Voltage 1.150v ............ 1.100V [1.190V]
CPU PLL 1.800v ....................... 1.800v [1.800V]
Thanks so much. Just built the new system and configured the BIOS to you recommendation. However, my BIOS only allows changing dram voltage by increments of .20, so my options for this setting are 1.40v and 1.60v. Which would you recommend?
Comment