These settings can be used for most DDR2-1066 memory packages on this motherboard.
Make these changes in your BIOS:
Set Memory Clock - Manual
Memory Clock - x5.33 1066MHz
DCTs Mode - Unganged
System Voltage Control - Manual
DRAM Voltage - 2.1V
DRAM Configuration (submenu)
CAS# Latency - 5
RAS to CAS R/W Delay - 5
Row Precharge Time - 5
Minimum RAS Active Time - 15
1T/2T Command Timing - 2
TwTr Command Delay - 4
Trfc 0 for DIMM1 - 127
Trfc 2 for DIMM2 - 127
Trfc1 for DIMM3 - 127
Trfc3 for DIMM4 - 127
Write Recovery Time - 8
Precharge Time - 4
Row Cycle Time - 27
RAS to RAS Delay - 4
Save and exit.
Thank you
GSKILL SUPPORT
Make these changes in your BIOS:
Set Memory Clock - Manual
Memory Clock - x5.33 1066MHz
DCTs Mode - Unganged
System Voltage Control - Manual
DRAM Voltage - 2.1V
DRAM Configuration (submenu)
CAS# Latency - 5
RAS to CAS R/W Delay - 5
Row Precharge Time - 5
Minimum RAS Active Time - 15
1T/2T Command Timing - 2
TwTr Command Delay - 4
Trfc 0 for DIMM1 - 127
Trfc 2 for DIMM2 - 127
Trfc1 for DIMM3 - 127
Trfc3 for DIMM4 - 127
Write Recovery Time - 8
Precharge Time - 4
Row Cycle Time - 27
RAS to RAS Delay - 4
Save and exit.
Thank you
GSKILL SUPPORT
Comment