F3-12800CL9D-4GBNQ unstable at 1600 on GA-MA770T-UD3P

[ocer]

thanks

i will give that a try and update the results!

[ocer]

i tried the suggested settings but 1600Mhz still fails. Any other inputs that maybe i can try?

[harrysun]

CPU: AM3 720
MB: MA770T-UD3P
Memory: G.Skill F3-12800CL9-2GBNQ 2GB DIMM DDR3 PC3-12800U DDR3-1600 (9-9-9-24 4-33-10-5)

Here are my test cases for the combo: http://bit.ly/2i9Ukw (OpenOffice Calc) No one worked!

I was able to send the memory back and bought a different manufacture. I hope this helps somebody to continue the profiling and find a working solutions. I stopped the evaluation because @1333 did not work too. I'm a little bit disapoited with the motherboard manufacture too, because this modules are declared as qualified.

[GSKILL TECH]

Try updating your BIOS, also try increasing DRAM Voltage to 1.70V.

Trfc0 for DIMM1 160ns
Trfc2 for DIMM2 110ns
Trfc1 for DIMM3 160ns
Trfc3 for DIMM4 110ns

Thank you
GSKILL SUPPORT

[phildaman46]

After a few weeks my computer was working fine at 1600, but it didn't last. I'm getting the same problems again. There are some hidden bios settings with CTRL+F1 under memory timings. Would these make a difference?

DQS Training Control [Skip DQS] (next setting is Perform DQS)
CKE Power Down Mode [Disabled]
Memclock tri-stating [Disabled]
Bank Swizzle Mode Enabled

Or should I increase the DRAM Voltage Control again?